Simaudio MOON Titan HT-200 Owner's Manual download pdf (Page 6)

MOON Titan HT-200 Multi-Channel Power Amplifier

Rear Panel Layout

Figure 1: MOON Titan HT-200 Rear panel

Regardless of the number of channels your amplifier has, the rear panel will look similar to Figure 1 (above). Depending on

the number of channels built into your MOON Titan HT-200 Multi-Channel power amplifier, a corresponding number of input

connectors and output connectors are located on the back panel. If your amplifier has, for example, five channels, then the

two extra sets of connectors for the non-existing 6th and 7th channels are replaced by factory-inserted hole plugs. Should

you wish us to upgrade your amplifier by adding extra channels, we will remove the plugs and install the necessary

connectors to accommodate the extra channels.

Each channel has a balanced input on an XLR connector and a single-ended (unbalanced) input on RCA connector. There is no

switch to toggle from balanced mode to single-ended mode. You may operate the amplifier in either mode, but only one mode

at one time for each channel. Above each of these inputs is a pair of heavy duty gold-plated speaker binding posts (“-” and

“+”) for each speaker.

On the lower mid-section you will find; The power “main switch” (“0”=off, “1”=on); the “on/off” push button; the “AC Fuse”

socket cover; and the “AC” 20 ampere IEC receptacle for the power cord.To the left of the “on/off” push-button is a “12V

trigger” input on a 1/8” mini-jack. This allows for the MOON Titan HT-200 to be turned “on” or “off” using a hard wired

remote connected to this input.

____________________________________________________________________________________

Rear Panel Layout 6

1 2 3 4 5 6 7 8 9

No comments

Simaudio MOON Titan HT-200 Owner's Manual Page 6