Simaudio MOON P-3 Owner's Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 13
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
MOON P-3 Stereo Preamplifier
Rear Panel Connections
Figure 2: Rear panel of Moon P-3 Stereo Preamplifier
The rear panel will look similar to Figure 2 (above). There are eight (8) pairs of single-ended
(unbalanced) inputs on RCA connectors labeled CD, A1, A2, A3, A4, A5, A6 and A7. The left channel
inputs are located on top and the corresponding right channel inputs are located directly below. The
A4 input, as previously mentioned, bypasses the gain stage and is intended to be used with a
component, such as a home theater processor, that has its own volume/gain control.
The MOON P-3 Stereo preamplifier has three (3) pairs of outputs; One single-ended pair labeled
‘Tape Out’, located next to the A7 input, that is intended as an input to a recording device such as a
cassette tape deck or CD-Recordable Player. Keep in mind that the output level on the ‘tape out’ is
fixed and cannot be adjusted by the P-3’s volume control. A second single-ended pair of RCA
connectors labeled ‘Left Out’ and ‘Right Out’, located on opposite sides of the rear panel, is designated
for output to a power amplifier with single-ended RCA inputs. The third pair of outputs are balanced
XLR connectors intended for use with an amplifier using balanced XLR input connectors. We strongly
recommend that you use the balanced output connectors on your P-3 to maximize its level of
performance. As well, don’t hesitate to use high quality interconnect cables. Poor quality interconnect
cables can degrade the overall sonic performance of your system.
The P-3 has a headphone jack located on the lower left side of the rear panel. The audio signal for
this output can be turned on or off by using the “Mute” button located on the front panel. By holding
down the “Mute” button for two seconds you will activate or de-activate the ‘headphone output’ located
on the rear panel.
You will notice that all RCA input and output connectors on the rear panel have been color coded:
‘white’ for the left channel and ‘red’ for the right channel.
____________________________________________________________________________________
Rear Panel Connections 9
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments